Which characteristic of the network layer in the OSI model allows carrying packets for multiple types of communications among many hosts? |
the ability to operate without regard to the data that is carried in each packet |
What are two characteristics of IP? (Choose two.) |
does not require a dedicated end-to-end connection operates independently of the network media |
When a connectionless protocol is in use at a lower layer of the OSI model, how is missing data detected and retransmitted if necessary? |
Upper-layer connection-oriented protocols keep track of the data received and can request retransmission from the upper-level protocols on the sending host. |
Which field in the IPv4 header is used to prevent a packet from traversing a network endlessly? |
Time-to-Live |
What IPv4 header field identifies the upper layer protocol carried in the packet? |
Protocol |
What is one advantage that the IPv6 simplified header offers over IPv4? |
efficient packet handling |
Refer to the exhibit. Which route from the PC1 routing table will be used to reach PC2? |
Network Destination 192.168.10.0 Netmask 255.255.255.0 Gateway Onlink Interface 192.168.10.10 Metric 281 |
Refer to the exhibit. R1 receives a packet destined for the IP address 192.168.2.10. Out which interface will R1 forward the packet? |
Refer to the exhibit. R1 receives a packet destined for the IP address 192.168.2.10. Out which interface will R1 forward the packet? |
What type of route is indicated by the code C in an IPv4 routing table on a Cisco router? |
directly connected route |
What routing table entry has a next hop address associated with a destination network? |
remote routes |
Which statement describes a hardware feature of a Cisco 1941 router that has the default hardware configuration? |
It has two types of ports that can be used to access the console. |
Following default settings, what is the next step in the router boot sequence after the IOS loads from flash? |
Locate and load the startup-config file from NVRAM. |
What are two types of router interfaces? (Choose two.) |
LAN WAN |
Which two pieces of information are in the RAM of a Cisco router during normal operation? (Choose two.) |
Cisco IOS IP routing table |
A router boots and enters setup mode. What is the reason for this? |
The configuration file is missing from NVRAM. |
What is the purpose of the startup configuration file on a Cisco router? |
to contain the commands that are used to initially configure a router on startup |
Which three commands are used to set up secure access to a router through a connection to the console interface? (Choose three.) |
line console 0 login password cisco |
Which characteristic describes an IPv6 enhancement over IPv4? |
The IPv6 header is simpler than the IPv4 header is, which improves packet handling. |
Open the PT Activity. The enable password on all devices is cisco. For what reason is the failure occurring? |
SW1 does not have a default gateway configured. |
Match the command with the device mode at which the command is entered. (Not all options are used.) |
R1(config)# -> service password-encrytion R1> -> enable – not scored – R1# -> copy running-config startup-config R1(config-line)# -> login R1(config-if)# -> ip address 192.168.4.4 255.255.255.0 |
CCNA1 – Chapter 6
Share This
Unfinished tasks keep piling up?
Let us complete them for you. Quickly and professionally.
Check Price