|
You are building network cables and attaching RJ45 connectors to each end. Which tool do you need for this task? |
Crimping Tool |
|
What tool should you use to extend network services beyond the demarc? |
Punchdown tool |
|
You are making Ethernet drop cables using Cat5e cable and RJ45 connectors. You need to remove the plastic coating over the cable to expose the individual wires. Which tool should you use? |
Cable Stripper |
|
You are working with 25 pair wires and 66 blocks. You have pushed the wires onto the 66 block, but now need to cut off the excess end of each wire. Which tool should you use? |
Punchdown tool |
|
Which of the following connector types are used with UTP cables? (Select two.) |
-RJ11 -RJ45 |
|
Which of the following describes the point where the service provider’s responsibility ends and the customer’s responsibility for installing and maintaining wiring and equipment? |
Demarc |
|
You have a network that occupies all three floors of a building. The WAN service provider has installed the line for the WAN service into the building in a wiring closet on the main floor. You have a wiring closet on the two remaining floors directly above the wiring closet on the main floor. What would you use to connect the wiring closets together? |
Vertical Cross Connect |
|
You have a network that occupies the top floor of a three story building. The WAN service provider has installed the line for the WAN service into the building in a wiring closet on the main floor. What would you use to relocate the WAN line into a wiring closet on your floor? |
Demarc Extension |
|
You have a network that occupies all three floors of a building. The WAN service prodider has installed the line for the WAN service into the building in a wiring closet on the main floor You have a second wiring closet on the main floor. You need to connect the two wiring closets. Which of the following are typically used to connect the two wiring closets? (Select two.) |
-25 Pair -Horizontal cross connect |
|
You have a network that occupies both floors of a building. The WAN service provider has installed the line for the WAN service into the building in a wiring closet on the main floor. You have a second wiring closet on the second floor directly above the wiring closed that holds the demar. Which of the following describes the closet on the second floor? |
IDF |
|
Which of the following is used to terminate individual wires from a 25 pair or 100 pair cables using female RJ-45 ports? |
Patch panel |
|
You want to use the T568B standard for adding connectors to your Cat5 cable. Starting with pin 1, which order should you use for the wires within the connector? |
White/orange, orange, white/green, blue, white/blue, green, white/brown, brown |
|
Which of the following methods would you use to create a crossover cable? |
Use the T568A standard on one connector, and the T568B standard on the other connector |
|
You need to terminate a Cat 6 UTP cable with and RJ045 connector. Your organization’s IT policy states that all cable connectors must be wired according to TIA568A standards Drag the UTP wire on the left to the correct pin in the RJ45 connector on the right |
Pin 1: White w/ green stripe Pin 2: Solid Green Pin 3: White with orange Stripe Pin 4: Solid blue Pin 5: white w/ blue stripe Pin 6: solid orange Pin 7: white w/ brown stripe Pin 8: Solid brown |
Share This
Flashcard
