Quiz 6 CCNA

Your page rank:

Total word count: 323
Pages: 1

Calculate the Price

- -
275 words
Looking for Expert Opinion?
Let us have a look at your work and suggest how to improve it!
Get a Consultant

Match the action to the corresponding command. (Not all options are used.)

assigns VLAN 10 for untagged traffic

activates the current interface as trunk

prohibits VLAN 10 on the trunk interface

switchport trunk native vlan 10 switchport mode trunk switchport trunk allowed vlan remove 10

Open the PT Activity. Perform the tasks in the activity instructions and then answer the question.
Which ping command from PC0 to PC1 completes successfully?


What is the meaning of the number 10 in the encapsulation dot1Q 10 native router subinterface command?​


What is the purpose of the switch command switchport access vlan 99?

to assign the port to a particular VLAN

Which step should be performed first when deleting a VLAN that has member switch ports?

Reassign all VLAN member ports to a different VLAN.

If an organization is changing to include Cisco IP phones in its network, what design feature must be considered to ensure voice quality?

A separate VLAN is needed for voice traffic.

In which location are the normal range VLANs stored on a Cisco switch by default?

flash memory

Refer to the exhibit. Which implementation of inter-VLAN routing does this topology use?

router on a stick

Using legacy inter-VLAN routing, how many physical router interfaces have to be configured to support 5 VLANs?


Which distinct type of VLAN is used by an administrator to access and configure a switch?

management VLAN

Refer to the exhibit. All workstations are configured correctly in VLAN 20. Workstations that are connected to switch SW1 are not able to send traffic to workstations on SW2. What could be done to remedy the problem?

Allow VLAN 20 on the trunk link.

Refer to the exhibit. What is the cause of the error that is displayed in the configuration of inter-VLAN routing on router CiscoVille?

The encapsulation dot1Q 20 command has not been configured.​

For what reason would a network administrator use the show interfaces trunk command on a switch?

to view the native VLAN

Share This

More flashcards like this

NCLEX 10000 Integumentary Disorders

When assessing a client with partial-thickness burns over 60% of the body, which finding should the nurse report immediately? a) ...

Read more


A client with amyotrophic lateral sclerosis (ALS) tells the nurse, "Sometimes I feel so frustrated. I can’t do anything without ...

Read more

NASM Flashcards

Which of the following is the process of getting oxygen from the environment to the tissues of the body? Diffusion ...

Read more

Unfinished tasks keep piling up?

Let us complete them for you. Quickly and professionally.

Check Price

Successful message