Digital signals are composed of pulses of precise, positive voltages and zero voltages. |
True |
Because digital signals do not depend on amplitude or frequency differences to communicate information, they are more vulnerable to EMI noise. |
False |
What two items below are commonly expressed as bits transmitted per second? |
throughput, bandwidth |
What two connector types are typically used to terminate RG-6 and RG-59 cables? |
f-connectors, BNC |
What is the maximum supported throughput and bandwidth / signal rate of Cat 5e? |
1000 Mbps |
What Ethernet standard below is also referred to as "thinnet"? |
10Base2 |
How many cable pairs are needed for 1000Base-T transmission over CAT5e cable? |
4 |
Standard PoE devices must be provided with how much power in order to function? |
15.4 watts |
What type of cross-talk occurs between wire pairs near the source of a signal? |
near end cross talk |
Which of the following connectors is the most common for multimode fiber? |
MT-RJ |
A measure of a signal’s strength at any given time is known as which term below? |
amplitude |
The number of times that a wave’s amplitude cycles from its starting point, through its highest amplitude and its lowest amplitude, and back to its starting point over a fixed period of time, is known as what term below? |
frequency |
Phone companies make use of what type of multiplexing in order to allow for phone services and DSL services over the same line? |
FDM |
The most common multiplexing technology used in conjunction with fiber optics is which option below? |
DWDM |
Since cable TV and cable Internet can share the same coaxial cable, they are considered to be what type of technology? |
broadband |
The amount of data that a medium transmits during a given period of time. |
throughput |
An unwanted connection, such as when exposed wires touch each other. |
short circuit |
A multiplexing technique used over single-mode or multimode fiber-optic cable in which each signal is assigned a different wavelength for its carrier wave. |
DWDM (Dense Wavelength Division Multiplexing) |
A Physical layer standard for networks that achieves 1 Gbps over Cat 6 or better cabling using only two pairs of wires. |
1000Base-TX |
Physical layer standard for networks that specifies 1-Gbps transmission over fiber-optic cable using baseband transmission, relying on 1300 nanometer wavelengths. |
1000Base-LX |
A character encoding system consisting of 128 characters. |
ASCII |
A form of transmission that allows multiple signals to travel simultaneously over one medium. |
multiplexing |
The distance between corresponding points on a wave’s cycle, expressed in meters or feet. |
wavelength |
A term used to refer to a type of twisted-pair cable. All of the category cables fall under the TIA/EIA 568 standard.Cross-talk measured at the far end of the cable from the signal source. |
Cat (category) |
Cross-talk measured at the far end of the cable from the signal source. |
far end cross-talk (FEXT) |
Network + Chapter 5
Share This
Unfinished tasks keep piling up?
Let us complete them for you. Quickly and professionally.
Check Price