you are troubleshooting physical layer issues with Gi0/1 interface in a router. you need to view and analyze the number of collisions detected on the interface |
show interfaces Gi0/1 |
You are troubleshooting physical layer issues with the G0/1 interface on a router. You suspect a duplex mismatch error has occurred and need to determine the duplex settings configured on the interface. Which commands should you use? |
show interfaces gi0/1 show interfaces gi0/1 status |
Review the output from the show interfaces far/1 command on the switch 2 switch in the exhibit. what is wrong with the fa0/1 interface in this example? |
A duplex mismatch exists with the device on the other end of the connection. |
Consider the network shown in the exhibit. When you run the show interface command on switch1, you observe a significant number of runts on the Gio/1 interface. What does this statistic indicate? |
Collisions are occurring. |
You are reviewing the output of the show interfaces command for the Gi0/1 interface on a switch. You notice significant number of CRC errors displayed. What are the most likely causes? select two |
Collisions EMI or cross-talk on the cable connected to the interface |
You are reviewing the output of the show interfaces command for the Gi0/1 interface on a switch. Which interface statistic displays the number of collisions that occurred after the 64th byte of the frame was transmitted? |
Late collisions |
A workstation is connected to a switch on the Gi0/2 interface using a straight-through cable. The ethernet interface in the workstation has bee manually configured to use a 100Mbps link speed in full-duplex mode. Which of the following are true in this scenario? select three |
The switch attempts to sense the link speed If the link speed is 100Mbps or 100Mbps, half-duplex is used. If the link speed is 1000Mbps or faster, full-duplex is used. |
Consider the network shown in the exhibit. |
The devices connected to fa0/1 interface has auto negotiation disabled |
Your organization recently opened a branch office in a remote area. Because of its location, traditional WAN connectivity was not available. so you contracted with a satellite provider to connect the branch office network to your home office network. What is the most likely cause of this poor WAN performance. |
There is latency on the WAN link. |
Your organization recently opened a branch office. You contracted with a WAN service provider to connect the branch office network to your home office network. What is the most likely cause of this poor WAN performance. |
The WAN provider is throttling bandwidth on the link |
Your organization recently opened a branch office. You contracted with a WAN service provider to connect the branch office network to your home office network. |
There is a problem with the service providers network The WAN interface on one or both routers have been disabled. |
Your organization recently opened a branch office. You contracted with a WAN service provider to connect the branch office network to your home office network. |
There is a data link encapsulation protocol mismatch between the WAN interfaces on both ends of the link. |
Your organization recently opened a branch office. You contracted with a WAN service provider to connect the branch office network to your home office network. |
There is an authentication misconfiguration issue the WAN interfaces on both ends of the link |
Your organization recently opened a branch office. You contracted with a WAN service provider to connect the branch office network to your home office network. |
There is an IP address misconfiguration issues between the WAN interfaces on both ends of the link. |
11.5.4 Practice exam
Share This
Unfinished tasks keep piling up?
Let us complete them for you. Quickly and professionally.
Check Price